Deako Smart Lighting | Multi-way Smart Switch Upgrade

Section title


Step 1 of 5

Remove faceplates


Uninstall the Deako Faceplates from all switches in the circuit by pulling from both corners.

Step 2 of 5

Unplug the existing Deako Switches


  • a. Use your thumb and your index finger to pull the blue tab outwards
  • b. Pull the Deako Switch outwards

Step 3 of 5

Plug in Deako Smart Switches


Install your new Deako Smart Switches into all the Deako Backplates in the circuit.
  • a. Insert the switch into the Deako Backplate
  • b. Align the blue tab with the slot on the Deako Switch
  • c. While pressing the switch inwards, push in the blue tab

Step 4 of 5

Replace the faceplates


Replace the Deako Faceplates by snapping them onto the backplates.

Step 5 of 5

3-way & 4-way linking


Deako Smart Switches and Smart Dimmers are single-pole by default. To change them into 3-way and 4-way switches, follow the instructions above.

If you would prefer written instructions, click here.

Troubleshooting

If a switch continues flashing for more than a minute, exit pairing mode by pressing and holding the switch for 6 seconds. Then, before retrying, factory reset each switch in the circuit. How do I factory reset a Deako Switch?


You're all done!


If you have installed Deako Smart Products, click below to learn more about the Deako App.




If you would prefer a PDF of the installation guide, click here to download it.